ISO 17025 accredited
Up to 8 inches
4 to 80 TPI
Minor Diameter not measured on Rings less than 1/4 inch.
Gage ID Number
Description and Size of Gage
Check Points (if not specified, we adhere to our quality policy)
Gage ID is the unique identifier you use to identify the specific piece of equipment.
Calibration Cycle is the interval between calibrations.
We use this information to provide a sticker for the calibrated instrument to show when it was calibrated and when you want it calibrated again.
Please include power cords, leads, and any accessories necessary for us to perform the calibration.
All ISO 17025 accredited calibrations are traceable through NIST or another NMI(National Metrology Institute) to the SI Unit.
Calibration certificates include as-found data, as-left data, and measurement uncertainty.
11402 Reading Road
Cincinnati, OH 45241
We do offer onsite calibration service within a 150-mile radius. Not all calibrations are best suited for onsite calibration.
Please contact Customer Service with your specific question.
The minimum order is $100.
November 9, 2021
October 26, 2021
October 13, 2021
September 29, 2021