Gage ID Number
Description and Size of Gage
Calibration Cycle
Check Points (if not specified, we adhere to our quality policy)
ISO 17025 accredited
Capabilities:
AC/DC Current- Measure: 10mA to 200A
AC Current Frequency- Measure: 40 Hz to 1 kHz
AC/DC Current- Source: 3.3 mA to 200A
AC Current Frequency- Source: 20Hz to 1 kHz
A shunt is a low-value resistor used to measure current – it is therefore also referred to as a current-sense resistor. The shunt typically connects in series so it carries the current of interest. A voltage measurement device then connects in parallel with the shunt. The current through the shunt generates a voltage drop that is measured. The current value is derived from Ohm’s law and the known resistance (I = V/R). To keep power loss – and thus heat development – to a minimum, shunts must have resistive values no higher than the milliohm range. Some are even below that.
The advantage of this measuring method is that it allows the quick detection and elimination of faults. Shunts are therefore particularly interesting for safety-relevant applications where faults must be detected. Furthermore, shunts deliver precise measurements and thus enable the efficient control of drives or the monitoring of battery management systems. And shunt resistors are an excellent value for money.
Bert Weiss, Rutronik Elektronische Bauelemente GmbH
Gage ID Number
Description and Size of Gage
Calibration Cycle
Check Points (if not specified, we adhere to our quality policy)
Gage ID is the unique identifier you use to identify the specific piece of equipment.
Calibration Cycle is the interval between calibrations.
We use this information to provide a sticker for the calibrated instrument to show when it was calibrated and when you want it calibrated again.
YES!
Please include power cords, leads, and any accessories necessary for us to perform the calibration.
All ISO 17025 accredited calibrations are traceable through NIST or another NMI(National Metrology Institute) to the SI Unit.
Calibration certificates include as-found data, as-left data, and measurement uncertainty.
Alliance Calibration
11402 Reading Road
Cincinnati, OH 45241
We do offer onsite calibration service within a 150-mile radius. Not all calibrations are best suited for onsite calibration.
Please contact Customer Service with your specific question.
The minimum order is $100.
No.
June 17, 2022
May 30, 2022
May 16, 2022
May 2, 2022
